HRESULT 0x803100AE (FVE_E_NOT_ALLOWED_ON

Status / error code:

Category:

Constant name:

Source:

Facility:

Operating System:

Description:

This command cannot be performed on a volume when it is part of a cluster.

Previous	Next
FVE_E_NOT_ALLOWED_ON_CSV_STACK	FVE_E_EDRIVE_NO_FAILOVER_TO_SW

FVE_E_NOT_ALLOWED_ON_CLUSTER

The failed prerequisite

FVE_E_NOT_ALLOWED_ON_CLUSTER / 0x803100AE marks a rejected BitLocker transition: the requested BitLocker operation is not supported while the volume participates in a failover cluster.

Note: Thin provisioning reports virtual size separately from allocated backing space. When diagnosing this result, remember: Operations that write every free extent can consume the entire pool without adding user data.

Diagnostic map

Layer	cluster or thin-storage coordination
Proof to collect	cluster membership, resource group, CSV status, owner node, maintenance mode and requested operation
Different condition	FVE_E_NOT_ALLOWED_ON_CSV_STACK, where coordinator placement rather than universal cluster prohibition is the issue
First safe change	use the documented cluster BitLocker workflow or remove the volume from clustered service only through an approved maintenance plan

Note: Cluster Shared Volumes and thin-provisioned storage add ownership and allocation semantics that a standalone disk does not have. When diagnosing this result, remember: BitLocker operations must respect the CSV coordinator and must not force thin backing storage to allocate every virtual extent.

A focused verification sequence

record cluster membership, resource group, CSV status, owner node, maintenance mode and requested operation. Keep the full HRESULT and the first method that returned it because later cleanup calls can report a different state.
capture manage-bde -status and the protector inventory for the exact volume GUID, not only the drive letter, because letters can change in WinRE, clusters and deployment environments.
Export BitLocker operational events for the result failure and note the boot session, caller identity and management source; that evidence separates this BitLocker condition from a generic access or storage error.

Recommended operational response

use the documented cluster BitLocker workflow or remove the volume from clustered service only through an approved maintenance plan.
After correcting the result prerequisite, refresh protection, conversion and lock state before one controlled retry; a cached UI message is not proof that the condition is still active.
Before a this result remediation deletes protectors, changes firmware mode, resizes partitions or decrypts a production drive, verify that an independent recovery method is available and escrowed in the intended directory or account.

Get-ClusterSharedVolume | Format-List *
manage-bde -status

Interpretation checkpoint

This result identifies a condition but not every owner of the surrounding state. Preserve the original caller, volume GUID and event sequence so the correction is applied at the right layer.

State checks specific to it

Checkpoint	How to interpret it for it
Before the call	Record the target identity and the pre-call cluster or thin-storage coordination state. The decisive boundary is that the requested BitLocker operation is not supported while the volume participates in a failover cluster.
At failure	Preserve cluster membership, resource group, CSV status, owner node, maintenance mode and requested operation. This proves whether it came from BitLocker itself or from a wrapper translating another result.
After correction	Use the documented cluster BitLocker workflow or remove the volume from clustered service only through an approved maintenance plan. The request should then advance without removing an unrelated recovery route.
After reboot or remount	Recheck protection, conversion and lock state for it; a successful management call is incomplete if the next boot cannot unlock the volume.

Verification after the change

Success means more than the absence of a dialog. Confirm that the condition represented by it now matches the intended design, that the protector inventory has not lost an independent recovery route, and that the next reboot or remount can unlock the volume. If the request advances to another HRESULT, record both values in order because that transition reveals the next unmet prerequisite.

Official references

Reference set for it:

Looking for a different code? Search another status or error code.